Table leaves a blank page and jumps to start at top of following page
Combs, Richard
richard.combs at Polycom.com
Tue Feb 10 14:37:59 PST 2009
Avraham Makeler wrote:
> I have a table where the whole table jumps to start at the page that
> follows
> the table's insertion page, so leaving a blank page. So the table's
anchor
> point is left at the top of the blank page, and the actual table
itself
> starts at the top of the next page.
>
> What is going wrong?
Numerous possibilities. Check these:
-- In Table Designer, Basic tab, is Start set to Top of Page (or
something else causing the same outcome)?
-- In the same place, is Orphan Rows set to a number too high to allow
the table to break across pages?
-- For each row, select Table > Row Format. Check the row's Start Row
and Keep With settings.
-- In addition, look for possible interactions of these settings. For
instance, as others noted, a row can't break across pages. If you row 3
is too tall to fit on the first page, but rows 1 and 2 are set to Keep
With Next, or Orphan Rows is set to 3, then FM has to pull the whole
thing down a page to conform to the settings.
HTH!
Richard
Richard G. Combs
Senior Technical Writer
Polycom, Inc.
richardDOTcombs AT polycomDOTcom
303-223-5111
------
rgcombs AT gmailDOTcom
303-777-0436
------
More information about the framers
mailing list