Table leaves a blank page and jumps to start at top of following page

[Avraham Makeler]

On Wed, Feb 11, 2009 at 9:52 AM, Avraham Makeler <amakeler at gmail.com> wrote:

> >> Is the table defined with too many rows for the page?
> Yes, I should have mentioned, the table is just longer than will fit in a
> single page.
>
> (I had already collapsed into bed when I remembered that I had forgotten to
> say that; had no energy to switch the PC back on; if PCs would take only a
> second to boot it would have been different...)
>
> I tested what would happen if I make the font small enough to allow the
> whole table to fit on the single page, and lo and behold the problem
> disappears.
>
> avi
>
>
>
> On Wed, Feb 11, 2009 at 12:21 AM, Deirdre Reagan <deirdre.reagan at gmail.com
> > wrote:
>
>> Is the table defined with too many rows for the page?
>>
>> On 2/10/09, Avraham Makeler <amakeler at gmail.com> wrote:
>> > Hi all,
>> >
>> > I have a table where the whole table jumps to start at the page that
>> follows
>> > the table's insertion page, so leaving a blank page. So the table's
>> anchor
>> > point is left at the top of the blank page, and the actual table itself
>> > starts at the top of the next page.
>> >
>> > What is going wrong?
>> >
>> > Thanks,
>> >
>> > avi
>> > _______________________________________________
>> >
>> >
>> > You are currently subscribed to Framers as deirdre.reagan at gmail.com.
>> >
>> > Send list messages to framers at lists.frameusers.com.
>> >
>> > To unsubscribe send a blank email to
>> > framers-unsubscribe at lists.frameusers.com
>> > or visit
>> http://lists.frameusers.com/mailman/options/framers/deirdre.reagan%40gmail.com
>> >
>> > Send administrative questions to listadmin at frameusers.com. Visit
>> > http://www.frameusers.com/ for more resources and info.
>> >
>>
>
>