Table ruling

[Wim Hooghwinkel - idtp]

Yes, true, although the second should be with only right most border
visible, I probably misunderstood Yves'question. 

Some other solutions are available by using two paragraphs: one for the Icon
and one for the warning text. Depending on the page layout: if you use side
heads place the Icon in the sidehead (Frame above or below) and the (table
with) warning text in column. Use a negative space above to align the table
with the Icon. Without side heads put the warning icon in a run-in paragraph
(Frame below) followed by a paragraph to contain the warning text (table).
Alternative construct can be to put the one cell icon table (fixed width) in
a run in paragraph, put the warning text table in the succeeding paragraph,
this table indented with the icon table's column width. Make the paragraph
have negative space below and the tables negative space above to align as
needed.

Not author-friendly, but it works.

Kind regards, vriendelijke groet,

Wim Hooghwinkel

Adobe Certified Expert (ACE) in FrameMaker

iDTP

International DTP and Documentation Consultancy
 
tel. +31652036811
info at idtp.eu 
www.idtp.eu
                                                                          


-----Oorspronkelijk bericht-----
Van: Baruch Brodersen [mailto:Baruch.Brodersen at bigbandnet.com] 
Verzonden: dinsdag 26 mei 2009 9:55
Aan: Wim Hooghwinkel - idtp
Onderwerp: RE: Table ruling

Wim,

That covers the column ruling of the one row table, but doesn't address the
row ruling (top-bottom) in right cell only.

Three one row, two cell tables are presented below. The first has borders
around each cell. The second is your solution, the thirds is what it sounds
like Yves is after.
______________
|______|_______| 

            |            |
            ________
            |_______| 

I don't think table #3 can be done in Table Designer without custom ruling
and shading. Can it?

Baruch


-----Original Message-----
From: framers-bounces at lists.frameusers.com
[mailto:framers-bounces at lists.frameusers.com] On Behalf Of Wim Hooghwinkel -
idtp
Sent: Tuesday, May 26, 2009 10:27 AM
To: framers at lists.frameusers.com
Subject: RE: Table ruling

Yves,

In this case you can set the Outside Ruling in the Table definition, set all
to 'None' and Right to have a border.

Or, use Column Ruling and set '2nd' to have a border and others to 'None'.

Kind regards, vriendelijke groet,

Wim Hooghwinkel

Adobe Certified Expert (ACE) in FrameMaker

iDTP

International DTP and Documentation Consultancy
 
tel. +31652036811
info at idtp.eu
www.idtp.eu


_______________________________________________


You are currently subscribed to Framers as baruch.brodersen at bigbandnet.com.

Send list messages to framers at lists.frameusers.com.

To unsubscribe send a blank email to 
framers-unsubscribe at lists.frameusers.com
or visit
http://lists.frameusers.com/mailman/options/framers/baruch.brodersen%40bigba
ndnet.com

Send administrative questions to listadmin at frameusers.com. Visit
http://www.frameusers.com/ for more resources and info.