[Framers] How do you guys abbreviate foot pounds and Newton meters when writing about torque settings?

[Carol J. Elkins]

Agreed. I always defer to the published standards for the industry 
I'm writing for. In my case, that would be the International System 
of Units, ASTM, and IEEE. See http://physics.nist.gov/cuu/Units/ and 
https://www.astm.org/FormStyle_for_ASTM_STDS.html in addition to the 
link provided by Robert.

Carol

At 08:33 AM 6/1/2017, Robert Lauriston wrote:
>Here's one standard: http://www.ewh.ieee.org/soc/ias/pub-dept/abbreviation.pdf
>_______________________________________________
>
>This message is from the Framers mailing list
>
>Send messages to framers at lists.frameusers.com
>Visit the list's homepage at  http://www.frameusers.com
>Archives located at 
>http://www.mail-archive.com/framers%40lists.frameusers.com/
>Subscribe and unsubscribe at 
>http://lists.frameusers.com/listinfo.cgi/framers-frameusers.com
>Send administrative questions to listadmin at frameusers.com