[Framers] Runaround properties for tables in FrameMaker?

[Lin Sims]

You can't do that using table properties. You could if you created a text
frame and inserted the table inside the frame. If you have standard table
configurations that take up the same space on the page, you could probably
save a text frame somewhere, copy and paste it in, then insert the table.
Or Silicon Prairie has the Autotext plugin which would let you set it up in
a document and insert as needed, frame and table at the same time.

Why are you trying to do this, btw? Is it because your tables aren't as
wide as the page so you want to take advantage of the blank space?

On Fri, May 10, 2019 at 2:07 PM Peter Kelly <peter.kelly at qio.io> wrote:

> Hi Framers,
>
> Have always had good advice from you so am out to test my luck again. Is
> there a way of specifying runaround properties for tables? Whenever I have
> a table in a main text flow, I am not able to make text runaround the
> table. I've only been able to make text precede and follow. Creating a two
> column layout for this just seems like a lot of work that would not be
> re-used. Any advice is appreciated.
>
> Best,
> Peter
> _______________________________________________
>
> This message is from the Framers mailing list
>
> Send messages to framers at lists.frameusers.com
> Visit the list's homepage at  http://www.frameusers.com
> Archives located at
> http://www.mail-archive.com/framers%40lists.frameusers.com/
> Subscribe and unsubscribe at
> http://lists.frameusers.com/listinfo.cgi/framers-frameusers.com
> Send administrative questions to listadmin at frameusers.com
>


-- 
Lin Sims